Wurth Adhesive for Plastic 50ml REPLAST® EASY TRANSPARENT Bodywork
For easily bonding plastic parts or repairing lamp housings, for example.
The substrate must be capable of bearing loads and must be clean, dry and free from grease and rust. Old adhesive residues must also be removed. Observe the processing instructions. For more information, refer to the technical data sheet.
For colourless bonding of transparent or coloured plastic parts
An adhesive for virtually every type of plastic
No need for inconvenient use of different types of adhesive
Can be used for repairs and fast attachment
Special positive mixer
Optimum mixing with minimum volumes
Low adhesive loss (waste)
Outstanding resistance to chemicals
Free of solvents
Min./max. processing temperature
15 to 25 °C
Min./max. temperature resistance
-35 to +90 °C
Shelf life from production/conditions
12 Month / at 23°C and 50% relative humidity, no exposure to direct sunlight
Not suitable for PE (polyethylene), PP (polypropylene) or PTFE (polytetrafluoroethylene). There may be adhesion problems in individual cases due to the coatings and release agents used in some cases in the plastic production process. Check material compatibility on a non-visible area if necessary.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.